Note: We recommend downloading these instructions as a
printable Adobe Acrobat PDF file by clicking here It may take a few moments to download, be patient. This file is 1.4MB
Figure 1. GeeWhiz® IMD
Selecting The Correct Size of the GeeWhiz
Prior to using the GeeWhiz IMD, select the “CORRECT SIZE” to best fit your needs. Available sizes are: 29 MM, 32 MM, 36 MM. Use the GeeWhiz Sizer™ template and follow instructions for best results. Make a record of your size for future reference and ordering.
NOTE: You may download, print, cut and use the Sizing Guide shown below from our website, www.urinedevice.com Download Chart and print at 100%. Or if you prefer, call 800/639-9323 and we will gladly mail you a full size Sizing Guide at no charge.
Cut along dotted lines.
Place openings over penile shaft behind the glans or head of penis to select correct size.
Below is for reference.
Please download the properly sized PDF file for accuracy.
CUT OUT STRIP. WRAP AROUND SHAFT OF PENIS. USE SIZE CLOSEST TO ARROW TIP
TO APPLY THE GEEWHIZ IMD
YOU WILL NEED THE FOLLOWING ITEMS
One GeeWhiz Daily Pak™ containing:
1-GeeWhiz® catheter with male QuickSnap™ nozzle in tip
1-GelStrip™™ silicone adhesive strip
1-SecureStrip™ Wrapping Tape
1 Length of connector tubing
Leg Bag or Bedside Drain Bag (not Shown)
It’s As Simple As 1, 2, 3!
Quick Reference Guide for Applying the GeeWhiz® IMD
Refer to Instruction Booklet & Read Complete Instructions Before Using Product
Remove both plastic liners from the GelStrip™ adhesive gel and place the GelStrip™ on the surface of the penis behind the glans. While applying a slight tension to the GelStrip™, wrap it completely around the outside of the penis. Overlap the GelStrip™ and press it into place around the penis – DO NOT CUT!
NOTE: Application Method Differs With The Non-Circumcised Male. The Foreskin Must First Be Pulled Forward Over The Glans Of the Penis Before The GelStrip™ Is Wrapped Around The Penis Behind The Glans!
Place the head of the penis into open end of catheter. Unroll the catheter onto the penis, over, and all the way across the GelStrip™ until the rolled end of the catheter is behind the edge of the GelStrip™ nearest your body. Squeeze the catheter around the circumference of the GelStrip™ to insure complete contact and a good seal.
Remove the protective liner from the SecureStrip™. Center the tape on the outside GelStrip™ “Bump” surface of the catheter over the GelStrip™ “Bump.” While applying a slight tension to the tape, wrap it completely around the outside of the catheter – DO NOT CUT!
CAUTION: Do not wrap so tightly as to restrict the flow of urine or blood.